Questions & Answers

Do i have to use relay for (-) start and (-) ignition on a 2003 highlander.

0 votes
All wired up but not sure for the negative ignition and negative start that is not indicated in the diagram.
asked Oct 16, 2019 in Toyota by Emmanuel Padsican (480 points)

1 Answer

0 votes
 
Best answer
If you need (+) outputs, you will need a relay. Those outputs exist incase the main harness does not have enough outputs to cover a vehicles ignition switch or for completely other purposes. It doesnt look like you will need those on the 2003 Highlander.

 

You need to..

1- Find out what circuits are required on the vehicles ignition switch. most likely ignition1, ignition2, accessory, start.

2- wire accordingly the evo main harness to the vehicle.
answered Oct 16, 2019 by Robert T (297,620 points)
selected Oct 16, 2019 by Emmanuel Padsican
if you connected those outputs to something it would explain why your module blew from the other post :D
Okay thank you. Can give me the steps how to program ftxduo on an evo one. I m confused i see lots of programming and im not sure what one to use.

Do you have the EVO-START2 antenna that goes with that FTXDUO?

 

Take a look at page 2 of this guide for pairing instructions. https://fortin.ca/download/70001/ftxduo-install-guide-70001.pdf

 

 

Just saw your location. The EVO-START2 is not available in your area. You could technically still get the evo-start2 with FTXDUO remote but i honestly dont see the point :D  https://www.evo-start.ca/home

 

The RFK642 or 641 might be a better choice. https://fortin.ca/en/technology/rf_kits.html

 

Would it be better the if i use evo - start2 rather than evo one?

evo-start2 is an antenna that can only be used in parts of Quebec and ontario. It plugs into the EVO-ONE. It runs on a private data network. It's an app based telematics antenna to control lock-unlock-start from your phone. The optional companion remote to that antenna is the FTXDUO. Using the FTXDUO remote gives you confirmation on your phone when the car starts. But as i said, the service for EVO-START2 is available in Quebec and Ontario only. No reason to buy the EVO-START2 + FTXDUO if you are out of the coverage zone. 

 

You need the EVO-ONE, it's the main controller. How you control, tell it what to do, is up to you. Any of the remotes we list, aside from the EVO-START2 and FTXDUO, would be good to go https://fortin.ca/en/technology/rf_kits.html

...