Evo-one does not do anything when remote button is pressed.

Question

I have a 2006 ford fusion. I know I have everything hooked up correctly, but for the life, I do not know what else to do. Please help.

Answer 1

Hi Eddie, from the service number you gave I can see that the Dcryptor process has gone through but you need to hit the 'Update Module' button to transfer the key code to the EVO-ONE. This will transfer the info from the flash-link to the EVO-ONE unit. Secondly, the options on the Bypass side of the EVO-ONE are off. You must enable A1-A11 so the options and features will work properly for your vehicle. Ex . If foot brake is turned off then you can not disengage the remote starter when you get in the vehicle and hit the brake pedal. Try out these suggestions and let us know if you get it to work. If you need further assistance give tech support a call toll free at 1-877-336-7797. Thanks

Answer 2

Hi,

3 issues

1. please set function 31 to mode 4 on the remote starter side of the Evo-One,

2. you did not update the unit after the dcryptor process, please re-connect and click on the process dcryptor tab and click on Update Unit.

3, Please do not click on TOGGLE while the Evo unit is plugged in the the Flashlink Updater-2,  Toggle to connection mode::Bypass and plug in evo, access the evo-one options tab and make sure that A1 to A11 is ON and that you can see the green and red buttons on your screen, then click on save options.

 

Thank you,