Questions & Answers

2013 Dodge Ram

0 votes
2013 dodge ram tip start

 

I'm using the "glacier start" remote starter kit from Grand West Enterprises.  It said I needed to connect the yellow ignition wire to the ignition source at the brake controller harness.  I tested it and it does get power on ignition.  I don't know what else to try.
asociée à une réponse pour: can bus program stays blue
fermer comme doublon de: Programming EVO-ALL
posté Nov 4, 2013 dans la catégorie Dodge par Ken Making (310 points)
fermé Nov 4, 2013 par Robert T

1 Réponse

+1 vote
 
Meilleure réponse

In this programming procedure, there are a few steps to follow and a minimum required firmware.

 
What is the 12-digit service number written on the back of the EVO?

Are you using a T-Harness (THAR-CHR3 or THAR-CHR6)?

 

Note: reply by using the comment button below

répondu Nov 4, 2013 par Robert T (300,070 points)
élue Nov 19, 2013 par Robert T
Service Number
posté Nov 4, 2013 dans la catégorie Dodge par Ken Making (310 points)
fermé Nov 4, 2013 par Robert T
Really, the only reason it normally stays on Solid is because it does not see ignition On. If the Can-Bus was at fault, then the LED would shut off and stay off.

I'd recommend disconnecting the 20-Pin white connector from the EVO-ALL, and with a multi-meter, test the voltage on the Yellow wire.
commenté Nov 4, 2013 par Robert T (300,070 points)
modifié Nov 4, 2013 par Robert T

Questions associées:

...