Is the T-harness I received with EVO-VWT1 wired incorrectly?

Question

I installed an EVO-ALL using the EVO-VWT1 kit on a 2015 VW Jetta Push-to-Start.  The EVO-ALL does not power up when I plug in the black datalink connector from the T-Harness.  It powers and programs just fine on the Flashlink programmer connector.  I think the T-harness connector is bad but would appreciate some guidance on how to address this.

Answer 1

Hello,

I have seen this a few times, you are plugged into the wrong connector at the steering column. You should be on the connector that is at the back of the metal box under the column.

https://cdn02.fortin.ca/download/70121/EVO-ONE_IG_THR_BI_VOL1-JETTA_2015_PTS_TB_A_70121.pdf

Best regards.

Comments

You are correct!!! Thank you so much.  I feel kinda stupid not catching that before as I looked at it mutiple times and still looked right past it.