Datalink Protocols Disabled

I know this question has been asked but seen no official answer on it. I was trying to enable D2D (F3) in Datalink Protocols and couldn't as they are greyed out. Can't turn them on or off. I'm using the recommended firmware for my 2021 Jeep Cherokee PTS with evo-all firmware 68.03.

asked Jul 12, 2023 in FAQ by Chris LaMonica (130 points)

1 Answer

Hello,

What is the S/N number on the back of the evo?

Best regards.

answered Jul 12, 2023 by derek g (341,280 points)

SN: 001A07 352664

commented Jul 12, 2023 by Chris LaMonica (130 points)

What brand and model of remote starter are you pairing the evo-all with?

commented Jul 12, 2023 by derek g (341,280 points)

If section H is enabled (which it currently is on your module) then you cannot change the data link protocols.

Turn off option H in the evo and this will allow you to select different data link protocols.

Your module also does not appear to be set up properly if you are using the evo-all with a remote starter.

commented Jul 12, 2023 by derek g (341,280 points)

Thanks!

commented Jul 12, 2023 by Chris LaMonica (130 points)
reshown Jul 12, 2023 by Chris LaMonica

Questions & Answers

Datalink Protocols Disabled

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Questions & Answers

Datalink Protocols Disabled

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions