Questions & Answers

2011 Mustang Clutch bypass

0 votes
What is the Trigger Wire pin for clutch bypass on a 2011 Mustang GT Fortin Evo One with the Thar-For4 T Harness?

I checked regular installation guide and Thar-For4 guide and I do not see any ground out wire on the diagram. Ive considered running a relay off the starter (+) to power the relay which would be triggered by the ebrake signal and that relay would then bypass the clutch switch. The only issue I have with that is if the ebrake is up and car is in gear and someone else gets in my car it will start without the clutch.

I see many of the other Fortin Guides have specific Manual install guides trigger wires with diodes for the clutch bypass. I do not see any off this for 10-14 Mustangs.
asked Dec 10, 2019 in Ford by james wright2 (240 points)

1 Answer

0 votes
 
Best answer

The generic evo-one guide has info on all the generic wiring. https://cdn02.fortin.ca/download/68451/rm441-install-guide-68451.pdf

 

Clutch is a (-)trigger, Blue/orange wire at clutch switch. 

 

Could use dark blue A8 - GWR, green A4 (-)ignition, or white A5 (-)start

 

Ive considered running a relay off the starter (+) to power the relay which would be triggered by the ebrake signal and that relay would then bypass the clutch switch. The only issue I have with that is if the ebrake is up and car is in gear and someone else gets in my car it will start without the clutch.

dont do this, can be a hazard one day as you said. 

answered Dec 10, 2019 by Robert T (297,620 points)
selected Dec 10, 2019 by james wright2
So with a (-) Trigger I would only need to directly splice A5 into the Blue/Orange clutch switch? This needs an inline Diode to prevent backfeeding of a ground when the clutch is being used in normal operation? 1 Amp diode should work as that is what the other guides suggest?
Dont need a diode. It's only used on other guides when more than one clutch trigger is needed so that the circuits stay isolated from each other.
I really appreciate all of your help. Preparing for an install this weekend and trying to make sure I cover all my bases!

 

So with this I see some people using a relay with the ground as the trigger wire and splicing into both sides of the clutch switch. Could I just splice in the ground to the computer side of the clutch switch with this ground?
Clutch bypass is different on every make-model and year.

All you hsould need on a 2011 mustang is the output of evo to clutch trigger on car.
...