Questions & Answers

2016 Honda Fit - Evo One - Can't get pass the yellow lights to blink in step 5

0 votes
I have a 2016 Honda Fit key ignition

I used the THAR-ONE-HON2 T-harness

Ignition A1 is showing 12 volts in the on/run position

A10 is connected with THAR-HON-B1 with male and female T-harness
asked Nov 8, 2018 in Honda by brent morden (130 points)

1 Answer

0 votes
I see you have done dcryptor at least once. Are you sitll having issues?
answered Nov 8, 2018 by derek g (324,940 points)

I spliced the parking lights 12-pin connector
And the horn to 20-pin steering column.

I did get pass step 5 got the blinking yellow light

The car was running without shutting down with the immobilizer.

As I was doing this found that the pin on A1 was lose on the 20-pin connector T-harness THAR-HON-B1. Most likely the source of my problem.

I tried a again to proceed to step 6.
This time the vehicle check charge system.

I've checking my fuse's, non are blown two primary fuse boxes. Could it be a relay with the A1 connection going in and out? 

I've tried charging the battery.
Did a battery test
I've tried disconnected the remote car starter.

The car still goes in check charge system.

Yes I did try and decrypt the key. After exausting some options

thanks

...