Questions & Answers

2015 F350 programming issues wont read CanBus

0 votes
So ive tried leaving the red plug, unplugged hasent worked, I have to unit at version 71.28 as needed. So ive got it past the immobilizer part, plugged everything in used first key red and blue are on and yellow is on when the first key is in, second key goes in no yellow light this time, back to first key, still only red and blue on. no blinks just solid from the start. door locks cycle but thats it. ive checked my CAN high and CAN low connections, changed then and soldered them. ive checked my door pin wires A18,A17, there soldered to now. but still no luck now ive ran my parking light to behind my light swich controls so i could avoid have to do all the relay crap but thats the only part ive altered. now it did work in my 2016 f350 so i dont understand what is goin on! any help is much appreciated!
asked Mar 29, 2018 in Ford by Dryden Milton (210 points)

1 Answer

0 votes
Please try just programming the CanBus, unplug everything from the evo, press and hold the programming button, insert datalink connector, release button when the blue led lights up, reconnect remaining connectors and turn the key to the Ignition position and take note on how the blue led reacts.

 

If everything is connected properly, blue should shut off and flash rapidly.

If the blue led does not shut off, then the evo is not getting a proper signal on the yellow wire in the 20 pin connector.

If blue led shuts off but does not flash, then the canbus wires are either backwards, on the wrong wires, or has a broken connection.
answered Mar 29, 2018 by Jesus Monroy (63,860 points)
...