Questions & Answers

can not complete programming

0 votes
Hi, i have EVO- ALL hardware vr. 6 firmware vr. 70.16 EVO-GMTx pre-loaded - with THAR -GM1V2

my car is malibu 2013 in saudi arabia

i have a problem, i can not complete programming

when it comes to step number 4 which is in 5 seconds. red led flashes once and i turned ignition off and removed the key and reinserted it and turned ignition on again but yelllow led did not flashes and blue led did not flashes. please help
asked Oct 26, 2015 in Chevrolet by Mohamed Abokhatwa (160 points)

1 Answer

0 votes
Follow the DCryptor progamming on page 7 : https://fortin.ca/download/28951/evo-all_evogmt1combo_revg.pdf

 

Also, make sure to select the proper vehicle. Currently the EVO is set to a 2012 Malibu and not 2013. This will be required for the Dcryptor to work properly.
answered Oct 26, 2015 by Robert T (297,620 points)
Thanks Robert for replay, but i did not get your point. you want to say that because my car is 2013 EVO will not work ?

The EVO-ALL will work but you need to follow a different type of programming procedure since the vehicle is not from North America.

 

Follow the DCryptor progamming on page 7 : https://fortin.ca/download/28951/evo-all_evogmt1combo_revg.pdf

Thanks Robert, but what about 2012 and 2013 you said before? because my car is 2013. will it work with 2013 model?
Module will owrk on a all the models.

Selecting the proper vehicle though when flashing the EVO is important so the DCryptor sends the key data into the right mode so that it can analise the key correctly.
...