Questions & Answers

Crimestopper coolstart g5 in a ford 2006 f150. what wires do I need?

0 votes
I have a 2006 Ford F150 I am installing a Crimestopper coolstart G5 with a key overide all. I understand the hookup to the key override all. what wires do I neeed for a minimum install with the crimestopper?
asked Feb 4, 2015 in Ford by Jeff Davis (180 points)

1 Answer

+2 votes
Follow connection 1c in guide number 26741 for the installation of the key override all.

Ground out when running from the remote starter NEEDS to be connected to the blue (-While running) wire on the key override all. RX and TX and Ignition has to be connected to the vehicle.

There is no "minimum install" possible in that vehicle, you will need to connect and power up all the necessary key wires (Ignition, ACC, Starter, 12v) also brake, parking light, tachometer connections have to be done at the Coolstart G5,
answered Feb 4, 2015 by Rico (52,140 points)
Thank you for the reply. The key override all goes to RX and TX from the ignition barrel. Can I make my connections from the barrel wires a few feet away? Then the blue while running goes to the gorund out when running.Then ignition goes to ignition wire in the harness?

 

The rest of the wires are straight forward. To me that is a minimal install number wise with this vehicle. There are no trunk accessories or manual transmission wires to worry about since this is an automatic and has no rear trunk relay.

 

Your help is certainly apprecaited and thanks again.
Coolstart ground out while running wire.
...