Won't start after install Fortin Evo All

Question

Recently flashed and installed a Fortin Evo all for my 2006 Dodge ram Standard key programmed to oem key. After everything is said and done it does not start. I click lock 3x red led turns on then yellow, then red turns off yellow is still on then blue blinks then both turns off with red blinking 3 times at the end then turns off, no start. As for as I know I only have to hook up 2 wires which is one purple and yellow wire coming from t-harness side, purple goes to a green/red wire(Mux A18) and yellow goes to yellow (+ignition A1). In need of some assistance as I live in minnesota and a remote start will do me wonders. Thank you in advance !

Answer 1

what is the service number of the module?

Comments

001A07 027541

---

Ok, options seem fine although there is no reason to have option G enabled.

First note, there is no stand alone installation guide for this vehicle anymore due to some vehicules overcranking slightly. There is more than the MUX and yellow to wire.

 

If you want to try it, the old guide was this (page 4). https://fortin.ca/en/download/64021/64021.pdf

---

Thank you for your help, I followed instructions off a couple youtube videos for my make and model. I will give this a try out, Seems like I still have to wire in D6 (white/red) goes to (+)Starter. D5 (white/blue) goes to (+)12v. And seems like I have to cut D3 (yellow/red) from D2 (yellow/blue)  then wire D3 (yellow/red) to (+)ignition (pink/yellow). I think thatss correct...

---

So I followed those instructions page 4. I have wired in the evo all according to that older guide which seems better because the ignition actually cycled and fuel pump primed but no start... red led flashes 3 times. What could possibly be wrong ? 20 pin side I have A1 yellow going to yellow on t-harness side. I have A18 (mux) wired into purple/brown wire on ignition switch plug. On Red plug I have D6 white/red wire going to Starter wire green/yellow, I have D5 white/blue wire going to 12v grey/red. I have cut D3 yellow/red and have it going to ignition pink/white wire. I am useing flash link manager firmware 74.[39]  flashed for 2006 dodge ram, automatic, oem key, no factory alarm. Did normal procedure for progamming oem key to evo all. Press lock 3x red led turns on with yellow coming on too. Then blue blinks a couple times. Inside car ignition cycles, fuel pump primes but no start. All led turns off then red led blinks 3 times... I almost have it working, so close but I feel like there is either something wrong with the flash link manager software, everytime I restart/reflash it the loading bar starting from the bottom left loads up to 25% only then a window pops up saying "louding module data" then it disappears, I have seen it countless times used on multiple car/make/models and all seemed to work just fine but of course not for me...

  Thank you in advance for the assistance.

---

The MUX (green/red) needs to go in the same spot mentionned in the old guide and not to the purple on the T-harness.

---

Okay, I have switched the green/red wire and it is now going to the purple/brown. Still same issue. No start 3 red blinks at the end. So I don't know if my car has an oem alarm or not. Does that matter when I flash it and could that be what is preventing my car from starting ? And doesn't option G need to be enabled to be able to use the oem key ? I will disable option G and try again. tia