evo-chrt4 dodge charger 2008 red light only

Question

when i connect the device to the using the T-harness then i insert the 4 pin data link while holding the button it is only giving a red light.

 

second then which connection type should i use for my car

Answer 1

Can you provide us with the service number for your Evo-All.

And the connection guide depends on how you are going to use the Evo-All in the vehicle, (with Remote starter through datalink, with Remote starter WITHOUT datalink, or Stand Alone)

Comments

"Step Three i cut the yellow wire from the female harness and link it to yellow/green in the 5 pin red."

 

 

I reread your comments and saw this, please make sure that the YELLOW  from the MALE side of the t-harness is connected to the YELLOW/GREEN of the RED 5 pin connector

---

I did that but i still have the same problem , please help

---

When you turn the key to the IGNITION position, does the Blue LED shut off??

---

And after doing the MASTER RESET,  you will NEED to reconnect the Evo All to the Flashlink-2 updater and make sure that options C1, D1 and D2 are toggled ON still and SAVE OPTIONS

---

The blue led didn't shut off , it is constant.

I did the master after that i enabled the c1 , d1 , d2.

what am facing if i reconnet the igition wire on the male / famale harness then it will will start blinking and the i response to the 3x buttons but it doesn't start the engine.

i know that i have to connect the yellow wire from the male harness to the yellow/green of the red 5 pin connector and the yellow that comes alone with the yellow in the 20 pin.