Questions & Answers

Programmed Evo All for 3x lock Start .Will start but shutsdown after a couple seconds

0 votes
2011 Town and Country
posté Dec 27, 2014 dans la catégorie Chrysler par Frederick McWilliams (160 points)

1 Réponse

0 votes
Can you provide the service number written on module ?
répondu Dec 27, 2014 par Frederick McWilliams (85,210 points)
Edited Question with service #
commenté Dec 27, 2014 par Frederick McWilliams (160 points)
Make sure you connected yellow wire coming from t-harness to yellow wire on the 20 pin connector of the evoall.
commenté Dec 27, 2014 par Frederick McWilliams (85,210 points)
Yes that was done
commenté Dec 27, 2014 par Frederick McWilliams (160 points)
is the yellow wire showing 12v when ignition is on and 0v when ignition is off ?
commenté Dec 27, 2014 par Frederick McWilliams (85,210 points)
Do I need to reprogram unit in car after updating
commenté Dec 27, 2014 par Frederick McWilliams (160 points)
modifié Dec 27, 2014 par Frederick McWilliams
Yes it does show 12v on and 0v when off
commenté Dec 27, 2014 par Frederick McWilliams (160 points)
Master reset and reprogram

Hold button, insert 4 pin connector, release on RED led, press again program button and hold until leds start to alternate then release. This is master reset procedure, now disconnect 4 pin and reprogram your module.
commenté Dec 27, 2014 par Frederick McWilliams (85,210 points)
Will I need to reupdate it with FlashLink or just in vehicle
commenté Dec 27, 2014 par Frederick McWilliams (160 points)
works. just whent thru in vehicle programming
commenté Dec 27, 2014 par Frederick McWilliams (160 points)

Questions associées:

...