Is it possible for the EVO ALL to unprogram itself or reset itself while connected to the car?

Question

Service Number: 001A06368710

I know I ask too many questions and thank you for always helping me out. Can you verify if I have all the settings correct in the EVO ALL? I have the flashlink tool if I need to make changes. This is my issue now; The car (2015 Subaru WRX STI Manual trans. with standard key), EVO ALL and Compustar CM7000AS. I installed everything and the car was doing reservation mode and remote starting fine for 3 days and then out of no where it stopped working. The Remote start/alarm system works fine (but will not go into reservation mode) and I can unlock and lock the doors with the aftermarket remote. It is not in valet mode. Is like the EVO ALL is no longer sending the outputs for (tach, hand brake or neutral) or has becomed unprogrammed from the car. No connections are loose. I will reset and reprogram the EVO ALL again to the car and see if its starts working again but I am concerned that it may happen again. Any feedback is appreciated. Thank you.

Answer 1

Make sure the yellow wire of the EVOALL is connected to ignition, and make sure this ignition stays 12v even when cranking.

The compustar give you parking light flash to tell you why it didn't go into reservation mode.

Do you have the FT-DAS connected to your remote start ?