Tahoe 2006 Fortin evo-one+RF642W

Question

Evo-one, It is established according to Guide # 23261, +RF642W. No remote start. The starter does not twist. When doors are closed, it is armed. When unlocking the door is not disarmed.

Regards,

Viktor.

Answer 1

Does the ignition light up when trying to remote start vehicle?

Comments

No. But I hear the relay click into the block. If I repeat the remote start attempts several times, the yellow indicator sometimes blinks briefly.

I tried everything, master reset, programming, firmware 70.21 and 70.30. The result has not changed.

When the ignition is switched on with the key, the yellow indicator lights up.

I think the following (and / or):

1. There is no car identification during programming.

2. Incorrect setting options. Now installed by default.

3. Not a valid firmware version.

4. Why is not disarmed when unlocking the doors.

 

I hope for your help. Thank you.

 

---

Try using version 70.18 re program and re test.

 

Do lock and unlock work from rf kit?

---

Good. I'll try version 70.18 and report the result.

Yes, lock and unlock work from rf kit.

---

Also if parking lights were connected when you try to remote start the vhicle and it does not start they should flash X amount of times to tell you why it did not start. Just something to keep in mind. If theyw erent connected you can stick a test light on the parking light output and count the flashes.

---

Yes, the parking lights are connected, they blink when trying to remote start. I do not remember exactly .... 3 or 4 times. Today I will clarify.

Question. If I use version 70.18, connect the connection in accordance with Manual No. 23441?

Checked. When I try to start remotely, the ignition does not turn on. The parking lights flash 4 amount.

---

 

So. Remote start is working. Thank you for your advice. The device was in the valet mode, so remote startup was not performed.
But there was a problem when unlocking the doors using the remote control from the RF kit, disarming is not happening. When I open the door, the horn is triggered.

---

Problem! When the doors are unlocked using the remote control from the RF kit, disarming is not performed. When I open the door, a beep sounds.

In addition, when the remote startup is complete, the security system remains disarmed.

Thanks for any help.